Project Dashboard Canceled Guides Cleaning Plastic Parts for 3.0/3.1 Workflow

1 Extruder Body v3.7.11

Clean Support material from center hole and idler tab

Clean bottom of center hole so it is flat

Drill/Ream center hole with 8mm drill bit

Check holes for motor fit M3 screw

Check holes on base fit M4 screw

Check hole for M4 nuts

FreeCad Image
Uncleaned Extruder Body
Pull and break off support material from center.
Pull and break off support material from idler tab
Throw support material away.
Clean center hole with 8mm drlil bit
Smooth Bearing Hole with 7/8' Forsner bit. By hand only.
Cleaning on Extruder body

2 Extruder Idler

stuff

Done! Take me home